SMC Networks TigerAccess SMC7816M User Manual
Tigeraccess, Band vdsl2 switch
TigerAccess
™
EE
6-Band VDSL2 Switch
◆ 16 VDSL Downlink Ports (1 RJ-21 Connector)
◆ 2 Gigabit Ethernet Combination Ports (RJ-45/SFP)
◆ 1 Fast Ethernet Management Port (RJ-45)
◆ Non-blocking switching architecture
◆ Spanning Tree Protocol, RSTP, and MSTP
◆ Up to 12 LACP or static 8-port trunks
◆ Layer 2/3/4 CoS support through eight priority queues
◆ Layer 3/4 traffic priority with IP Precedence and IP DSCP
◆ Full support for VLANs with GVRP
◆ IGMP multicast filtering and snooping
◆ Manageable via console, Web, SNMP/RMON
◆ Security features: ACL, RADIUS, 802.1x
◆ VDSL line configuration using Long-Reach Ethernet
(LRE) commands, line profiles, and alarm profiles
Management Guide
SMC7816M/VSW
This manual is related to the following products:
Table of contents
Document Outline
- Section I Getting Started
- Section II Switch Management
- Chapter 3 Configuring the Switch
- Chapter 4 Basic Management Tasks
- Displaying System Information
- Displaying System Health
- Displaying Hardware/Software Versions
- Displaying Bridge Extension Capabilities
- Setting the Switch’s IP Address
- Configuring Support for Jumbo Frames
- Managing Firmware
- Saving or Restoring Configuration Settings
- Console Port Settings
- Telnet Settings
- Configuring Event Logging
- Resetting the System
- Setting the System Clock
- Chapter 5 Simple Network Management Protocol
- Chapter 6 User Authentication
- Chapter 7 Client Security
- Chapter 8 Access Control Lists
- Chapter 9 Port Configuration
- Chapter 10 VDSL Configuration
- Chapter 11 Address Table Settings
- Chapter 12 Spanning Tree Algorithm
- Chapter 13 VLAN Configuration
- Chapter 14 Class of Service
- Chapter 15 Quality of Service
- Chapter 16 Multicast Filtering
- Chapter 17 Domain Name Service
- Section III Command Line Interface
- Chapter 18 Overview of the Command Line Interface
- Chapter 19 General Commands
- Chapter 20 System Management Commands
- Chapter 21 SNMP Commands
- Chapter 22 User Authentication Commands
- Chapter 23 Client Security Commands
- Chapter 24 Access Control List Commands
- Chapter 25 Interface Commands
- Chapter 26 Link Aggregation Commands
- Chapter 27 Mirror Port Commands
- Chapter 28 Rate Limit Commands
- Chapter 29 VDSL Commands
- Long-Reach Ethernet Commands
- lre band-plan
- lre option-band
- lre ham-band
- lre region-ham-band
- lre psd-breakpoints
- lre psd-frequencies
- lre psd-value
- lre psd-mask-level
- lre pbo-config
- lre upbo
- lre tone
- lre max-power
- lre min-protection
- lre channel
- lre interleave-max-delay
- lre datarate
- lre rate-set
- lre noise-mgn target
- lre noise-mgn min
- lre shutdown
- lre reset
- lre auto-retraining
- lre retraining
- lre rate-adaption
- lre apply
- Line Profile Commands
- Alarm Profile Commands
- Displaying VDSL Information
- show lre band-plan
- show lre option-band
- show lre ham-band
- show lre region-ham-band
- show lre psd
- show lre psd-mask-level
- show lre pbo-config
- show lre upbo
- show lre tone
- show lre interleave-max-delay
- show lre datarate
- show lre noise-mgn
- show lre rate-adaption
- show lre config
- show lre line-profile
- show lre alarm-profile
- show lre
- show lre phys-info
- show lre rate-info
- show lre perf
- CPE Configuration
- Long-Reach Ethernet Commands
- Chapter 30 Address Table Commands
- Chapter 31 Spanning Tree Commands
- spanning-tree
- spanning-tree mode
- spanning-tree forward-time
- spanning-tree hello-time
- spanning-tree max-age
- spanning-tree priority
- spanning-tree pathcost method
- spanning-tree transmission-limit
- spanning-tree mst-configuration
- mst vlan
- mst priority
- name
- revision
- max-hops
- spanning-tree spanning-disabled
- spanning-tree cost
- spanning-tree port-priority
- spanning-tree edge-port
- spanning-tree portfast
- spanning-tree link-type
- spanning-tree mst cost
- spanning-tree mst port-priority
- spanning-tree protocol-migration
- show spanning-tree
- show spanning-tree mst configuration
- Chapter 32 VLAN Commands
- Chapter 33 Class of Service Commands
- Chapter 34 Quality of Service Commands
- Chapter 35 Multicast Filtering Commands
- Chapter 36 Domain Name Service Commands
- Chapter 37 DHCP Commands
- Chapter 38 IP Interface Commands
- Section IV Appendices