SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 157)

P
ORT
C
ONFIGURATION
3-107
CLI – This example shows the connection status for Port 13.
Configuring Interface Connections
You can use the Port Configuration or Trunk Configuration page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex mode, and flow
control.
Command Attributes
• Name – Allows you to label an interface. (Range: 1-64 characters)
• Admin – Allows you to manually disable an interface. You can disable
an interface due to abnormal behavior (e.g., excessive collisions), and
then reenable it after the problem has been resolved. You may also
disable an interface for security reasons.
• Speed/Duplex – Allows manual selection of port speed and duplex
mode (i.e., with auto-negotiation disabled).
• Flow Control – Allows automatic or manual selection of flow control.
Console#show interfaces status ethernet 1/13 4-183
Information of Eth 1/13
Basic information:
Port type: 100TX
Mac address: 00-30-F1-B0-E7-AD
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full
Broadcast storm: Enabled
Broadcast storm limit: 500 packets/second
Flow control: Enabled
LACP: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Current status:
Link status: Up
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Console#