SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 364)

C
OMMAND
L
INE
I
NTERFACE
4-102
• You can specify three authentication methods in a single command to
indicate the authentication sequence. For example, if you enter
“authentication enable radius tacacs local,” the user name and
password on the RADIUS server is verified first. If the RADIUS server
is not available, then authentication is attempted on the TACACS+
server. If the TACACS+ server is not available, the local user name and
password is checked.
Example
Related Commands
enable password (4-38)
RADIUS Client
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access to RADIUS-aware devices on the network. An authentication
server contains a database of multiple user name/password pairs with
associated privilege levels for each user or group that require management
access to a switch.
Console(config)#authentication enable radius
Console(config)#
Table 4-29 RADIUS Client Commands
Command Function Mode Page
radius-server host Specifies the RADIUS server GC 4-103
radius-server port Sets the RADIUS server network port GC 4-104
radius-server key Sets the RADIUS encryption key GC 4-104
radius-server retransmit Sets the number of retries GC 4-105
radius-server timeout Sets the interval between sending
authentication requests GC 4-105
show radius-server Shows the current RADIUS settings PE 4-106