SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 489)

VLAN C
OMMANDS
4-227
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment. This
section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic VLAN
registration for the selected interface.
Editing VLAN Groups
vlan database
Use this command to enter VLAN database mode. All commands in this
mode will take effect immediately.
Default Setting
None
Table 4-54 VLAN Commands
Command Groups Function Page
Editing VLAN Groups Sets up VLAN groups, including name, VID and
state
4-227
Configuring VLAN
Interfaces Configures VLAN interface parameters, including
ingress and egress tagging mode, ingress filtering,
PVID, and GVRP 4-230
Displaying VLAN
Information Displays VLAN groups, status, port members, and
MAC addresses 4-237
Table 4-55 Editing VLAN Groups
Command Function Mode Page
vlan database Enters VLAN database mode to add,
change, and delete VLANs GC 4-227
vlan Configures a VLAN, including VID, name
and state VC 4-228