SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 47)

B
ASIC
C
ONFIGURATION
2-11
2. To remove an existing string, simply type “no snmp-server community
string,” where “string” is the community access string to remove. Press
.
Trap Receivers
You can also specify SNMP stations that are to receive traps from the
switch.
To configure a trap receiver, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt,
type “snmp-server host host-address community-string,” where
“host-address” is the IP address for the trap receiver and
“community-string” is the string associated with that host. Press
.
2. In order to configure the switch to send SNMP notifications, you must
enter at least one snmp-server enable traps command. Type
“snmp-server enable traps type,” where “type” is either authentication
or link-up-down. Press .
Console(config)#snmp-server community abc rw
Console(config)#snmp-server community private
Console(config)#
Console(config)#no snmp-server community private
Console(config)#
Console(config)#snmp-server enable traps link-up-down
Console(config)#