Copy settings, Copy settings -192 – SMC Networks SMC TigerStack III SMC6824MPE User Manual
Page 242
C
ONFIGURING
THE
S
WITCH
3-192
CLI – The following example globally enables IP Port Priority service on
the switch, maps HTTP traffic on port 5 to CoS value 0, and then displays
all the IP Port Priority settings for that port.
Note: Mapping specific values for IP Port Priority is implemented as an
interface configuration command, but any changes will apply to
the all interfaces on the switch.
Copy Settings
Use the Copy Settings page to copy IP Precedence Priority Settings, DSCP
Priority Settings, and IP Port Priority Settings from a source port or trunk
to a destination port or trunk.
Note: Port priority settings apply globally to all ports on the switch. Due
to a hardware limitation individual port priority settings are not
possible.
Command Attributes
•
Copy IP Precedence Priority Settings – Enables or disables copying
IP Precedence Priority settings.
•
Copy DSCP Priority Settings – Enables or disables copying DSCP
Priority settings.
•
Copy IP Port Priority Settings – Enables or disables copying IP Port
Priority settings.
•
Source Interface – Specifies the port or trunk to copy settings from.
•
Destination Interface – Specifies the ports or trunks to copy settings
to.
•
Copy Settings – Carries out the command.
Console(config)#map ip port
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0
Console(config-if)#end
Console#show map ip port ethernet 1/5
TCP port mapping status: disabled
Port Port no. COS
--------- -------- ---
Eth 1/ 5 80 0
Console#