SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 495)

VLAN C
OMMANDS
4-233
Example
The following example shows how to restrict the traffic passed on port 1 to
tagged frames.
Related Commands
switchport mode (4-231)
switchport ingress-filtering
Use this command to enable ingress filtering for an interface. Use the no
form to restore the default.
Syntax
[no] switchport ingress-filtering
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Ingress filtering only affects tagged frames.
• If ingress filtering is disabled and a port receives frames tagged for
VLANs for which it is not a member, these frames will be flooded to all
other ports (except for those VLANs explicitly forbidden on this port).
• If ingress filtering is enabled and a port receives frames tagged for
VLANs for which it is not a member, these frames will be discarded.
• Ingress filtering does not affect VLAN independent BPDU frames, such
as GVRP or STA. However, they do affect VLAN dependent BPDU
frames, such as GMRP.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#