Using dhcp/bootp, Using dhcp/bootp -20, Figure 3-7 – SMC Networks SMC TigerStack III SMC6824MPE User Manual

Page 70: Ip configuration -20

Text mode
Original mode

ONFIGURING

THE

WITCH

3-20

Using DHCP/BOOTP

If your network provides DHCP/BOOTP services, you can configure the
switch to be dynamically configured by these services.

Web – Click System, IP Configuration. Specify the Management VLAN,
set the IP Address Mode to DHCP or BOOTP. Then click Apply to save
your changes. The switch will broadcast a request for IP configuration
settings on the next power reset. Otherwise, you can click Restart DHCP
to immediately request a new address.

Figure 3-7 IP Configuration

Note: If you lose your management connection, use a console

connection and enter “show ip interface” to determine the new
switch address.