Setting broadcast storm thresholds, Setting broadcast storm thresholds -124, Command usage – SMC Networks SMC TigerStack III SMC6824MPE User Manual
Page 174
C
ONFIGURING
THE
S
WITCH
3-124
CLI – The following example displays the LACP configuration settings
and operational state for the remote side of port channel 1.
Setting Broadcast Storm Thresholds
Broadcast storms may occur when a device on your network is
malfunctioning, or if application programs are not well designed or
properly configured. If there is too much broadcast traffic on your
network, performance can be severely degraded or everything can come to
complete halt.
You can protect your network from broadcast storms by setting a
threshold for broadcast traffic for all ports. Any broadcast packets
exceeding the specified threshold will then be dropped.
Command Usage
•
Broadcast Storm Control is enabled by default.
•
The default threshold is 500 packets per second.
•
Broadcast control does not effect IP multicast traffic.
Console#show 1 lacp neighbors
Channel group 1 neighbors
-------------------------------------------------------------------
------
Eth 1/1
-------------------------------------------------------------------
------
Partner Admin System ID : 32768, 00-00-00-00-00-00
Partner Oper System ID : 32768, 00-00-00-00-00-01
Partner Admin Port Number : 1
Partner Oper Port Number : 1
Port Admin Priority : 32768
Port Oper Priority : 32768
Admin Key : 0
Oper Key : 4
Admin State : defaulted, distributing, collecting,
synchronization,
long timeout,
Oper State : distributing, collecting, synchronization,
aggregation,
long timeout, LACP-activity
.
.
.
Console#