SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 163)

P
ORT
C
ONFIGURATION
3-113
• If more than four ports attached to the same target switch have LACP
enabled, the additional ports will be placed in standby mode, and will
only be enabled if one of the active links fails.
• All ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.
Web – Click Port, LACP, Configuration. Select any of the switch ports
from the scroll-down port list and click Add. After you have completed
adding ports to the member list, click Apply.
Figure 3-50 LACP Trunk Configuration