SMC Networks SMC TigerStack III SMC6824MPE - Manual (Page 244)

C
ONFIGURING THE
S
WITCH
3-194
Mapping CoS Values to ACLs
Use the ACL CoS Mapping page to set the output queue for packets
matching an ACL rule as shown in the following table. Note that the
specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. For information on mapping
the CoS values to output queues, see page 3-179.
Command Usage
You must configure an ACL mask before you can map CoS values to the
rule.
Command Attributes
• Port – Selects the port to which the ACL CoS is configured on.
• Name* – Name of ACL.
• Type – Type of ACL (IP or MAC).
• CoS Priority – Enables the CoS priority value level.
• Add – Adds the specified information to the port.
• ACL CoS Priority Mapping – Displays the configured information.
* For information on configuring ACLs, see page 3-88.
Table 3-15 Mapping CoS Values to IP ACLs
Queue 0 1 2 3
Priority 1,2 0,3 4,5 6,7