beautypg.com

Page 2 – loop parameters – Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual

Page 931

background image

Parameter

Description

START

(Knob 1)

Adjusts the playback’s start point in the Sample of the focused Zone.

END

(Knob 2)

Adjusts the playback’s end point in the Sample of the focused Zone.

Hold

SHIFT

when turning the Knobs to adjust the parameters in finer increments.

In the waveform on the right display, the regions outside the play range are grayed out.

Page 2 – LOOP Parameters

The parameters in the

LOOP

page allow you to define and adjust a portion that will play in loop

while the note is held.

The ZONE page on the controller, page 2 of 5: LOOP parameters.

Parameter

Description

ACTIVE

(Knob 1)

Enable this to define a loop in the Sample of the focused Zone.

When the play position reaches the loop, the playback is looped as
long as the note is held. This can be useful to loop either a whole

Sample or part of it, e.g., to simulate a longer tone. Note: this
technique requires that you set the Sampler’s

TYPE

selector to

AHD

or

ADSR

in the

PITCH / GATE

section (Parameter page 2, see

7.2.2, Page 2: Pitch / Envelope

).

START

(Knob 2)

Adjusts the start point of the loop.

Sampling and Sample Mapping

Mapping Samples to Zones

MASCHINE - Manual - 931