Inserting a plug-in, Removing a plug-in, Replacing a plug-in – Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual
Page 343

If the selected Plug-in slot was not empty, the previous Plug-in will be replaced with the new Plug-
in.
Instead of using the Plug-in Browser, you can also use the common Browser to load a particular pre-
set for a Plug-in (see section
4.2, Searching and Loading Files from the Library
).
Inserting a Plug-in
To insert a Plug-in directly after the selected Plug-in slot, do the following:
1.
Press
SHIFT
+ Button 3 (
INSERT
).
This automatically opens the Browser on your controller and locks the File Type to
EF-
FECT
(Button 1 and 2, normally used in the Browser to select the desired File Type, are
here disabled).
2.
Choose and load the desired Plug-in preset via the usual workflow in the Browser (see sec-
tion
3.3.7, Focusing on a Group or a Sound
→
When you finally press the 4-D encoder or Button 8 (
LOAD
), your controller automatically
switches back to Control mode and the new Plug-in is loaded in the next Plug-in slot. All
following Plug-ins are shifted one slot downwards to make room for the new Plug-in.
Removing a Plug-in
To remove a Plug-in from its slot, do the following:
►
Press
SHIFT
+ Button 8 (
REMOVE
).
→
The Plug-in is unloaded from the slot. All following Plug-ins are shifted one slot upwards
to fill the gap.
Alternatively, you can press
SHIFT
+
BROWSE
, turn the 4-D encoder (or Knob 8) to select
(none)
at
the top of the list in the right display, and press the 4-D encoder or Button 8 (
LOAD
).
Replacing a Plug-in
►
To replace a Plug-in, simply select its slot and load a new Plug-in as described above.
Working with Plug-ins
Plug-in Overview
MASCHINE - Manual - 343