Using the audio pool – Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual
Page 875
The name and length of the displayed Sample are indicated above the waveform. When the
Sample is played back (e.g., by pressing the fully lit pad), a playhead indicator (vertical line)
shows you the current play position within the waveform.
►
Turn Knob 5 to zoom in on the waveform of the Sample and Knob 6 to scroll through it.
Using the Audio Pool
All the recordings (takes) you have made since you opened the current Project are stored in the
Audio Pool and displayed as mini waveforms on the left display. The following actions are
available:
▪
To navigate your various recordings, press Button 7 (
PREV
) and Button 8 (
NEXT
).
▪
If you are using the Sampler plug-in:
◦
The selected recording is automatically loaded in the Plug-in and ready to be played.
◦
You can further edit the selected recording via the other pages of the Sampling mode.
When selected, a recording is also automatically mapped to a new Zone covering the
entire key and velocity ranges in the
ZONE
page. Any existing Zones will be replaced.
◦
You can press the fully lit pad (the focused Sound slot) to listen to the displayed re-
cording on the Cue bus (see section
for more informa-
tion).
▪
If you are using the Audio plug-in:
◦
The last take will automatically play back.
◦
You can set the Playback mode, the Engine mode and Source Tempo and Length.
▪
Press Button 6 (
DELETE
) to delete the selected take.
All recordings (takes) in the Audio Pool are saved with the Project. When you close the current
Project, all of your takes are saved as audio files and available for later use unless you explicitly
delete them (via the MASCHINE software or in your operating system).
Sampling and Sample Mapping
Recording Audio
MASCHINE - Manual - 875