Native Instruments MASCHINE MK3 Groove Production Studio (Black) - Manual (Page 810)

16.1.3.2 Jumping to Other Scenes using the Controller
In Ideas view the Perform Grid and the Retrigger controls the setting for jump between Scenes
and in Song view it sets the grid for the jump between Sections.
To set the Perform Grid and the Retrigger settings:
1.
Press ARRANGER .
2. Press SHIFT + Button 1 or 2 to select Ideas view or Song View.
3. Press and hold FOLLOW ( Grid ) to enter Grid mode (or pin it by pressing FOLLOW ( Grid ) +
Button 1).
4. Press Button 2 to select PERFORM .
5. Press a pad to select the desired value, for example pad 9 (for 1/4 , a quarter note).
→ The next time you select a new Scene/Section or loop range, the switch will happen on
the next quarter note.
Adjusting the Scene Retrigger Setting
To adjust the Scene Retrigger setting:
1.
Press and hold SCENE to enter Section mode (or pin it by pressing SCENE + Button 1).
2. At the bottom left corner of the left display you see the current RETRIGGER value ( Off by
default).
3. Turn Knob 1 to select On .
→ The next time you select a new Scene or loop range, it will start from the beginning.
Adjusting the Section Retrigger Setting
To adjust the Section Retrigger setting:
1.
Press and hold SHIFT + SCENE to enter Section mode (or pin it by pressing SCENE +
Button 1).
2. Press the Right Page button to access page 2.
Working with the Arranger
Arranger Basics
MASCHINE - Manual - 810