Bass synth parameters, A description of the bass synth parameters, 2, bass synth parameters – Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual
Page 477: 2 bass synth parameters, Main page

10.1.2 Bass Synth Parameters
Available from the both the Control area of the Arrange view and in the Plug-in Strip of the Mix
view, the parameters are as follows:
The parameters described are presented as they appear in the Control area (Arrange view). The
same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view). See
Main Page
Element
Description
OSC Section
Shape
Adjusts the waveform shape continuously from sine to square. To
adjust the waveform shape, turn the
Shape
knob by clicking and
dragging upwards or downwards. The waveform shape can be
viewed in the Plug-in Strip of the Mix view.
Octave
Transposes the base key of the Bass Synth (range: -3 – 3). To
transpose the base key, turn the
Octave
knob by clicking and
dragging upwards or downwards.
Filter Section
Cutoff
Adjusts the frequency of the low-pass filter (range: 14.6 Hz – 23.7
KHz). To adjust the cutoff frequency, turn the
Cutoff
knob by
clicking and dragging upwards or downwards.
Resonance
Adjusts the amount of boost around the cutoff frequency (range:
0.0% – 120%), Resonance can start to self-oscillate when
increasing the amount over 100.0 %. To adjust the amount of
resonance, turn the
Resonance
knob by clicking and dragging
upwards or downwards.
Envelope Section
Using the Bass Synth
Bass Synth – General Handling
MASCHINE - Manual - 477