beautypg.com

Page 1 – play range parameters – Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual

Page 881

background image

The Sample can be played back at any time by pressing the corresponding pad on your

controller. When the Sample is played back, the playhead indicator (vertical line) shows
you the current play position within the waveform on the right display.

The parameters available at the bottom of the left display are spread over two pages.

Use the Page buttons on the left of the displays to select the desired page.

Page 1 – PLAY RANGE Parameters

The parameters in the

PLAY RANGE

section allow you to adjust the range that will be played

back when you trigger a note.

The EDIT page on the controller, page 1 of 2: adjusting the play range of the Sample.

Parameter

Description

START

(Knob 1)

Adjusts the start point of the play range in the Sample.

END

(Knob 2)

Adjusts the end point of the play range in the Sample.

Hold

SHIFT

when turning the Knobs to adjust the parameters in finer increments.

In the waveform on the right display, the regions outside the play range are grayed out.

If a loop has been defined in the Sample, it is also indicated on the waveform. Loops can be creat-

ed and adjusted in the

ZONE

page — see section

17.5.4, Selecting and Editing Zones in the Map

View

. Note that the loop will always stay within the play range. Therefore, when moving the Sam-

ple’s start and end points closer to each other, keep in mind that it might also shrink the loop!

Sampling and Sample Mapping

Editing a Sample

MASCHINE - Manual - 881