Adjusting the slicing settings on the controller – Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual
Page 895
Parameter
Description
ADJUST
If
BPM
is set to
Auto
, you can choose between the tempo that
MASCHINE detected, or half or double of that tempo. If
BPM
is set
to
Manual
, you can adjust the tempo manually.
ENGINE Section
(Detect mode only)
ZERO-X
(Zero
Crossing, Detect mode
only)
When
MODE
is set to
Detect
, activate
ZERO-X
to force the detected
Slices to be created on the closest locations where the audio signal
crosses the zero value. This can be helpful to avoid clicks when
playing back Slices in another sequence.
Adjusting the Slicing Settings on the Controller
At the bottom of the left display, you can adjust the settings used to define where the various
Slices will be created in the Sample.
Adjust the slicing settings via Knob 1–4.
Any change to these settings will directly affect the number and position of the Slice markers
shown in the waveform on the displays.
Selecting and Pre-Listening the Slices with the Pads
At any time, the proposed Slices are also available on your pads: The fully lit pad indicates the
selected Slice, while the dim lit pads indicate the other Slices.
►
Press any fully or dim lit pad to play back the corresponding Slice on the Cue bus (see
section
Sampling and Sample Mapping
Slicing a Sample
MASCHINE - Manual - 895