PLANET CS-2001 - Manual (Page 96)

85
3.1.1 Modifying the LAN Interface (NAT / Routing)
Prerequisite Setup (Note: IP addresses used as examples only)
Port1 is configured as LAN1 by default. (IP address: 192.168.1.1, NAT/ Routing)
Step 1. Go to Network > Interface and then set as below:
（Figure 3-1）
 Click Port1’s Modify button.
 Select LAN for Interface Type.
 Select NAT Routing for Connection Type.
 Enter the IPv4 Address and Netmask.
 Tick Ping, HTTP and HTTPS.
 Click OK.
Figure 3-1 Modifying the LAN Interface
Note：
1. The LAN subnet is configured as 192.168.1.x/24 by default. After modifying the LAN subnet,
LAN PCs’ subnet must be modified as well for the LAN users to access the Web UI.