PLANET CS-2001 - Manual (Page 239)

228
Step 6. Under
Policy > Outgoing, set as below: （Figure 10-20）
 Source IP: Select the address setting.
 Service: Select the service setting.
 Action: Select Port2 (WAN1)
 Click OK.
（Figure 10-21）
Figure 10-20 Setting an Outgoing Policy
Figure 10-21 The Completed Settings
Important：
1. To enable the LAN to LAN connection, go to Policy > LAN to LAN and create a policy
(select Inside Any for both Source Address and Destination Address). To enable the DMZ to
DMZ connection, go to Policy > DMZ to DMZ and create a policy (select DMZ Any for both
Source Address and Destination Address).