PLANET CS-2001 User Manual

Page 60

2.3.2 Using Multiple Subnets to Establish a VLAN Gateway to

Regulate VLAN Users to Access the Internet

Prerequisite Setup (Note: IP addresses used as examples only)

Configure Port1 as LAN1 (192.168.1.1, NAT/ Routing mode) and connect it to the

LAN which is using 192.168.1.x/24.

VLAN ID 10 using 192.168.100.x/24.

VLAN ID 20 using 192.168.200.x/24.

Configure Port2 as WAN1(61.11.11.11) and connect it to the ADSL Termination Unit

Remote(ATUR) to access the Internet.

Configure Port3 as WAN2(211.22.22.22) and connect it to the ADSL Termination

Unit Remote(ATUR) to access the Internet.

Step 1. Go to System > Configuration > Multiple Subnet, and set as below:

 Click on New Entry.
 Fill in the Name field.
 Interface: Select Port1 (LAN1).
 IP Version: Select IPv4.
 IP Address: Type 192.168.100.1.
 Netmask: Type 255.255.255.0.
 Tick the VLAN ID checkbox and type in 10 into the VLAN ID field.
 Click OK.

（Figure 2-16）

 Click on New Entry again.
 Fill in the Name field.
 Interface: Select Port1 (LAN1).
 IP Version: Select IPv4.
 IP Address: Type 192.168.200.1.
 Netmask: Type 255.255.255.0.
 Tick the VLAN ID checkbox and type in 20 into the VLAN ID field.
 Click OK.

（Figure 2-17, 2-18）