PLANET CS-2001 - Manual (Page 230)

219
Step 6. Under
Policy > Outgoing, set as below: (Figure 10-6)
 Source Address: Select the LAN address.
 Service: Select Mail_Service.
 Click OK.
（Figure 10-7）
Figure 10-6 Configuring an Outgoing Policy
Figure 10-7 The Completed Policy Settings
Important:
1. To enable the LAN to LAN connection, go to Policy > LAN to LAN and create a policy
(select Inside Any for both Source Address and Destination Address). To enable the DMZ to
DMZ connection, go to Policy > DMZ to DMZ and create a policy (select DMZ Any for both
Source Address and Destination Address).