PLANET CS-2001 - Manual (Page 117)

106
Step 1. Go to Network > Interface and then set as below:
（Figure 3-19）
 Click Port1’s Modify button.
 Select LAN for Interface Type.
 Select NAT Routing for Connection Type.
 Enter the IPv4 Address and the Netmask.
 Tick Ping, HTTP and HTTPS.
 Click OK.
Figure 3-19 LAN Interface Settings
Step 2. Under Network > Interface, set as below:
（Figure 3-20）
 Click Port3’s Modify button.
 Select DMZ for Interface Type.
 Select Transparent Bridging for Connecion Type.
 Tick Ping, HTTP and HTTPS.
 Click OK.