PLANET CS-2001 - Manual (Page 131)

120
Step 2. Go to Network > Interface and then set as below:
（Figure 3-33）
 Click Port2’s Modify button.
 Select LAN for Interface Type.
 Select NAT/Routing for Connection Type.
 Enter the IPv4 Address and the Netmask.
 Tick Ping, HTTP and HTTPS.
 Click OK.
Figure 3-33 LAN Interface Settings
Step 3. Go to Network > Interface and set as below:
（Figure 3-34）
 Click Port3’s Modify button.
 Select LAN for Interface Type.
 Select Transparent Bridging for Connection Type.
 Tick Ping, HTTP and HTTPS.
 Click OK.
Figure 3-34 LAN Interface Settings