PLANET CS-2001 - Manual (Page 113)

102
Step 1. Go to Network > Interface and then set as below:
（Figure 3-16）
 Click Port2’s Modify button.
 Select LAN for Interface Type.
 Select Transparent Routing for Connection Type.
 Tick Ping, HTTP and HTTPS.
 Click OK.
Figure 3-16 Configuring the LAN Interface
Step 2. Go to Network > Interface and then set as below:
（Figure 3-17）
 Click Port3’s Modify button.
 Select LAN for Interface Type.
 Select NAT Routing for Connection Type.
 Enter the IPv4 Address and the Netmask.
 Tick Ping, HTTP and HTTPS.
 Click OK.
Figure 3-17 LAN
I