RIGOL DG1000Z Series - Manual (Page 95)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-83
[:SOURce[]]:BURSt:INTernal:PERiod
Syntax [:SOURce[]]:BURSt:INTernal:PERiod {|MINimum|MAXimum}
[:SOURce[]]:BURSt:INTernal:PERiod? [MINimum|MAXimum]
Description Set the internal burst period of the N cycle burst of the specified channel.
Query the internal burst period of the N cycle burst of the specified channel.
Parameter Name Type Range Default
[] Discrete 1|2 1
Real 2.016 6us to 500s 10ms
Explanation  When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 The burst period is only applicable to the N cycle burst mode
( [:SOURce[]]:BURSt:MODE ) in internal trigger and is defined as the time
from the start of a burst to the start of the next burst.
 The relation of the burst period, waveform period (the period of the burst
function (such as sine and square)) and the number of cycles of bursts is as
follows.
2us
+ × ≥
cycle waveform burst
N P P
Wherein,
burst
P —— burst period;
waveform
P
—— waveform period;
cycle
N —— number of cycles.
 If the specified burst period is too small, the signal generator will increase it
automatically to ensure the output of the specified number of cycles.
Return Format The query returns the burst period in scientific notation with 7 effective digits, for
example, 1.000000E-01 (the burst period is 0.1s).
Example :SOUR1:BURS:INT:PER 0.1 /*Set the internal burst period of the N cycle burst of
CH1 to 0.1s*/
:SOUR1:BURS:INT:PER? /*Query the internal burst period of the N cycle burst
of CH1 and the query returns 1.000000E-01*/
Related
Command
[:SOURce[]]:BURSt:MODE