RIGOL DG1000Z Series - Manual (Page 156)

RIGOL Chapter 2 Command System
2-144 DG1000Z Programming Guide
[:SOURce[]][:MOD]:PSKey:STATe
Syntax [:SOURce[]][:MOD]:PSKey:STATe {ON|1|OFF|0}
[:SOURce[]][:MOD]:PSKey:STATe?
Description Turn on or off the PSK modulation function of the specified channel.
Query the on/off status of the PSK modulation function of the specified channel.
Parameter Name Type Range Default
[] Discrete 1|2 1
{ON|1|OFF|0} Bool ON|1|OFF|0 OFF
Explanation  PSK (Phase Shift Keying): the signal generator shifts the output phase between
two preset phases (the carrier phase and modulation phase).
 The PSK carrier waveform could be Sine, Square, Ramp or Arbitrary waveform
(except DC). The default is Sine. Pulse, Noise and DC in the arbitrary waveform
could not be used as carrier waveform. The different settings of various
parameters (such as the frequency, amplitude, offset and start phase) of the
carrier waveform will influence the PSK modulated waveform.
 When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 If the sweep function ( [:SOURce[]]:SWEep:STATe ) or burst function
( [:SOURce[]]:BURSt[:STATe] ) is currently enabled, it will be disabled
automatically when the modulation function is turned on.
 If the harmonic function is currently enabled
( [:SOURce[]]:HARMonic[:STATe] ), the modulation function cannot be
turned on (the harmonic cannot be modulated).
Return Format The query returns ON or OFF.
Example :SOUR1:PSK:STAT ON /*Turn on the PSK modulation function of CH1*/
:SOUR1:PSK:STAT? /*Query the on/off status of the PSK modulation function
of CH1 and the query returns ON */
Related
Commands
[:SOURce[]]:BURSt[:STATe]
[:SOURce[]]:HARMonic[:STATe]
[:SOURce[]]:SWEep:STATe