RIGOL DG1000Z Series - Manual (Page 88)

RIGOL Chapter 2 Command System
2-76 DG1000Z Programming Guide
[:SOURce[]]:APPLy:NOISe
Syntax [:SOURce[]]:APPLy:NOISe
[|DEFault|MINimum|MAXimum[,|DEFault|MINimum|MAXimum]]
Description Set the waveform of the specified channel to noise with the specified amplitude and
offset.
Parameter Name Type Range Default
[] Discrete 1|2 1
Real Refer to the “Explanation” 5Vpp
Real Refer to the “Explanation” 0V
DC
Explanation  When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 The range of is limited by the “Impedance” ( :OUTPut[]:IMPedance
or :OUTPut[]:LOAD ) setting. The range of is limited by the
“Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:NOIS 1,2 /*Set the waveform of CH1 to noise with 1Vpp amplitude
and 2V
DC
offset*/
Related
Commands
:OUTPut[]:IMPedance
:OUTPut[]:LOAD
[:SOURce[]]:APPLy:PULSe
Syntax [:SOURce[]]:APPLy:PULSe
[|DEFault|MINimum|MAXimum[,|DEFault|MINimum|MAXimum
[,|DEFault|MINimum|MAXimum[,|DEFault|MINimum|MAXimum]]]]
Description Set the waveform of the specified channel to pulse with the specified frequency,
amplitude, offset and phase.
Parameter Name Type Range Default
[] Discrete 1|2 1
Real 1uHz to 25MHz 1kHz
Real Refer to the “Explanation” 5Vpp
Real Refer to the “Explanation” 0V
DC
Real 0° to 360° 0°
Explanation  When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 The range of is limited by the “Impedance” ( :OUTPut[]:IMPedance
or :OUTPut[]:LOAD ) and “Frequency/Period” settings. The range of
is limited by the “Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:PULS 100,3,2,1 /*Set the waveform of CH1 to pulse waveform with
100Hz frequency, 3Vpp amplitude, 2V
DC
offset
and 1° start phase*/
Related
Commands
:OUTPut[]:IMPedance
:OUTPut[]:LOAD