System:communicate:lan:autoip[:state, System:communicate:lan:control – RIGOL DG1000Z Series User Manual
Page 202

RIGOL
2-190
DG1000Z Programming Guide
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]
Syntax
:SYSTem:COMMunicate:LAN:AUTOip[:STATe] {ON|1|OFF|0}
:SYSTem:COMMunicate:LAN:AUTOip[:STATe]?
Description
Turn on or off the AutoIP configuration mode.
Query the status of the AutoIP configuration mode.
Parameter
Name
Type
Range
Default
{ON|1|OFF|0}
Bool
ON|1|OFF|0
ON
Explanation
Before using the LAN interface, connect the instrument to the PC or the
network of the PC using a network cable.
The instrument provides DHCP, AutoIP or ManualIP configuration modes.
In AutoIP mode, the signal generator acquires IP address within 169.254.0.1
and 169.254.255.254 and subnet mask 255.255.0.0 automatically according to
the current network configuration.
If all the three IP configuration modes are “On”, the priority of parameters
configuration from high to low is “DHCP”, “AutoIP” and “ManualIP”. Therefore,
to enable the AutoIP configuration mode, “DHCP” must be set to “Off”.
The three IP configuration modes cannot be set to “Off” at the same time.
After sending this command, the new settings will only take effect when
command is executed to apply the
current network parameters.
Return Format
The query returns ON or OFF.
Example
:SYST:COMM:LAN:AUTO OFF /*Turn off the AutoIP configuration mode*/
:SYST:COMM:LAN:AUTO? /*Query the status of the AutoIP configuration
mode and the query returns OFF*/
Related
Command
:SYSTem:COMMunicate:LAN:CONTrol?
Syntax
:SYSTem:COMMunicate:LAN:CONTrol?
Description
Query the number of the initial control connecting terminal used for socket
communication.
Return Format
The query returns 5555; if the interface does not support socket, the query returns
0.