RIGOL DG1000Z Series - Manual (Page 79)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-67
:SOURce Commands
The :SOURce commands are used to set and query the channel parameters, the related parameters of the
modulation, sweep and burst functions, the coupling and waveform summing functions as well as turn on
and off the corresponding function.
The frequency ranges available for the different models and different waveforms of DG1000Z series are as
shown in the table below.
Table 2-1 Frequency ranges available for the different models and different waveforms of DG1000Z series
Frequency Characteristic DG1032Z DG1062Z
Sine
Square
Ramp
Pulse
Harmonic
Noise (-3dB)
Arbitrary Waveform
1μHz to 30MHz
1μHz to 15MHz
1μHz to 500kHz
1μHz to 15MHz
1μHz to 10MHz
30MHz bandwidth
1μHz to 10MHz
1μHz to 60MHz
1μHz to 25MHz
1μHz to 1MHz
1μHz to 25MHz
1μHz to 20MHz
60MHz bandwidth
1μHz to 20MHz
Command List:
:SOURce:APPLy Commands
 [:SOURce[]]:APPLy?
 [:SOURce[]]:APPLy:ARBitrary
 [:SOURce[]]:APPLy:DC
 [:SOURce[]]:APPLy:HARMonic
 [:SOURce[]]:APPLy:NOISe
 [:SOURce[]]:APPLy:PULSe
 [:SOURce[]]:APPLy:RAMP
 [:SOURce[]]:APPLy:SINusoid
 [:SOURce[]]:APPLy:SQUare
 [:SOURce[]]:APPLy:TRIangle
 [:SOURce[]]:APPLy:USER
:SOURce:BURSt Commands
 [:SOURce[]]:BURSt:GATE:POLarity
 [:SOURce[]]:BURSt:INTernal:PERiod
 [:SOURce[]]:BURSt:MODE
 [:SOURce[]]:BURSt:NCYCles
 [:SOURce[]]:BURSt:PHASe
 [:SOURce[]]:BURSt[:STATe]
 [:SOURce[]]:BURSt:TDELay
 [:SOURce[]]:BURSt:TRIGger[:IMMediate]