RIGOL DG1000Z Series - Manual (Page 14)

RIGOL Chapter 2 Command System
2-2 DG1000Z Programming Guide
Note:
 In this manual, the range of the parameter in the command is based on DG1062Z.
 As all the commands are case-insensitive, for DG1000Z, MHZ (mhz) and MSA/S (msa/s) are
interpreted as megahertz and mega points per second respectively; while MVPP (mvpp), MVRMS
(mvrms), MVDC (mvdc), MV (mv) and MS (ms) are interpreted as millivolt (peak-peak value), millivolt
(effective value), millivolt (DC), millivolt and millisecond respectively.
 When the output impedance is HighZ, the amplitude unit dBm is invalid.