RIGOL DG1000Z Series - Manual (Page 152)

RIGOL Chapter 2 Command System
2-140 DG1000Z Programming Guide
[:SOURce[]][:MOD]:PM:STATe
Syntax [:SOURce[]][:MOD]:PM:STATe {ON|1|OFF|0}
[:SOURce[]][:MOD]:PM:STATe?
Description Turn on or off the PM modulation function of the specified channel.
Query the on/off status of the PM modulation function of the specified channel.
Parameter Name Type Range Default
[] Discrete 1|2 1
{ON|1|OFF|0} Bool ON|1|OFF|0 OFF
Explanation  PM (Phase Modulation): the phase of the carrier waveform changes with the
transient voltage of the modulating waveform.
 The PM carrier waveform could be Sine, Square, Ramp or Arbitrary waveform.
The default is Sine. Pulse, Noise and DC in the arbitrary waveform could not be
used as carrier waveform. The different settings of various parameters (such as
the frequency, amplitude and offset) of the carrier waveform will influence the
PM modulated waveform.
 When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 If the sweep function ( [:SOURce[]]:SWEep:STATe ) or burst function
( [:SOURce[]]:BURSt[:STATe] ) is currently enabled, it will be disabled
automatically when the modulation function is turned on.
 If the harmonic function is currently enabled
( [:SOURce[]]:HARMonic[:STATe] ), the modulation function cannot be
turned on (the harmonic cannot be modulated).
Return Format The query returns ON or OFF.
Example :SOUR1:PM:STAT ON /*Turn on the PM modulation function of CH1*/
:SOUR1:PM:STAT? /*Query the on/off status of the PM modulation function of
CH1 and the query returns ON*/
Related
Commands
[:SOURce[]]:BURSt[:STATe]
[:SOURce[]]:HARMonic[:STATe]
[:SOURce[]]:SWEep:STATe