Source[]]:burst:trigger[:immediate, Source[]]:burst:trigger:slope – RIGOL DG1000Z Series User Manual
Page 100

RIGOL
2-88
DG1000Z Programming Guide
[:SOURce[
Syntax
[:SOURce[
Description
Trigger a burst output immediately on the specified channel.
Parameter
Name
Type
Range
Default
[
Discrete
1|2
1
Explanation
This command is only applicable to the burst mode in manual trigger
[:SOURce[
). If the output of the
corresponding channel is not turned on (
), the trigger
will be ignored.
When [:SOURce[
CH1 by default.
Example
:SOUR1:BURS:TRIG /*Trigger a burst output immediately on CH1*/
Related
Commands
[:SOURce[
[:SOURce[
Syntax
[:SOURce[
[:SOURce[
Description
Set the edge type of the trigger input signal in the burst mode of the specified
channel to rising edge (POSitive) or falling edge (NEGative).
Query the edge type of the trigger input signal in the burst mode of the specified
channel.
Parameter
Name
Type
Range
Default
[
Discrete
1|2
1
{POSitive|NEGative}
Discrete
POSitive|NEGative
POSitive
Explanation
This command is only applicable to the burst mode (N cycle, infinite or gated)
in external trigger (
[:SOURce[
). When external
trigger is selected, the signal generator receives the trigger signal inputted
from the [Mod/Trig/FSK/Sync] connector of the corresponding channel at
the rear panel and initiates a burst output each time a TTL pulse with the
specified polarity is received.
When [:SOURce[
parameters of CH1 by default.
Return Format
The query returns POS or NEG.
Example
:SOUR1:BURS:TRIG:SLOP NEG /*Set CH1 to trigger on the falling edge of the
trigger input signal*/
:SOUR1:BURS:TRIG:SLOP? /*Query the edge type of the trigger input
signal of CH1 and the query returns NEG*/
Related
Command
[:SOURce[