RIGOL DG1000Z Series - Manual (Page 67)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-55
:OUTPut Commands
The :OUTPut commands is used to set and query the information related to the channel output and sync
signal, including setting and querying the channel output state, output polarity, output impedance, output
mode and gate polarity as well as setting and querying the output state, output polarity and delay time of
the sync signal.
Command List:
 :OUTPut[]:GATe:POLarity
 :OUTPut[]:IMPedance
 :OUTPut[]:LOAD
 :OUTPut[]:MODE
 :OUTPut[]:POLarity
 :OUTPut[][:STATe]
 :OUTPut[]:SYNC:DELay
 :OUTPut[]:SYNC:POLarity
 :OUTPut[]:SYNC[:STATe]
:OUTPut[]:GATe:POLarity
Syntax :OUTPut[]:GATe:POLarity {POSitive|NEGative}
:OUTPut[]:GATe:POLarity?
Description Set the gate polarity of the specified channel in the gated mode to POSitive or
NEGative.
Query the gate polarity of the specified channel in the gated mode.
Parameter Name Type Range Default
[] Discrete 1|2 1
{POSitive|NEGative} Discrete POSitive|NEGative POSitive
Explanation  When [] is omitted, the commands set and query the related parameters of
CH1 by default.
 In the gated mode ( :OUTPut[]:MODE ), the output state of the output
connector of the specified channel is controlled by the gated signal received by
the [Mod/Trig/FSK/Sync] connector of the corresponding channel at the rear
panel.
Positive: when the gated signal is high level, the channel output connector
outputs signal.
Negative: when the gated signal is low level, the channel output connector
outputs signal.
Return Format The query returns POSITIVE or NEGATIVE.
Example :OUTP1:GAT:POL NEG /*Set the gate polarity of CH1 in the gated mode to
negative*/
:OUTP1:GAT:POL? /*Query the gate polarity of CH1 in the gated mode and the
query returns NEGATIVE*/
Related
Command
:OUTPut[]:MODE