RIGOL DG1000Z Series - Manual (Page 90)

RIGOL Chapter 2 Command System
2-78 DG1000Z Programming Guide
[:SOURce[]]:APPLy:SINusoid
Syntax [:SOURce[]]:APPLy:SINusoid
[|DEFault|MINimum|MAXimum[,|DEFault|MINimum|MAXimum
[,|DEFault|MINimum|MAXimum[,|DEFault|MINimum|MAXimum]]]]
Description Set the waveform of the specified channel to sine waveform with the specified
frequency, amplitude, offset and phase.
Parameter Name Type Range Default
[] Discrete 1|2 1
Real 1uHz to 60MHz 1kHz
Real Refer to the “Explanation” 5Vpp
Real Refer to the “Explanation” 0V
DC
Real 0° to 360° 0°
Explanation  When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 The range of is limited by the “Impedance” ( :OUTPut[]:IMPedance
or :OUTPut[]:LOAD ) and “Frequency/Period” settings. The range of
is limited by the “Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:SIN 100,3,2,1 /*Set the waveform of CH1 to sine waveform with
100Hz frequency, 3Vpp amplitude, 2V
DC
offset and
1° start phase*/
Related
Commands
:OUTPut[]:IMPedance
:OUTPut[]:LOAD