RIGOL DG1000Z Series - Manual (Page 102)

RIGOL Chapter 2 Command System
2-90 DG1000Z Programming Guide
[:SOURce[]]:BURSt:TRIGger:TRIGOut
Syntax [:SOURce[]]:BURSt:TRIGger:TRIGOut {POSitive|NEGative|OFF}
[:SOURce[]]:BURSt:TRIGger:TRIGOut?
Description Set the edge type of the trigger output signal in the burst mode of the specified
channel to rising edge (POSitive) or falling edge (NEGative) or disable the trigger
output signal.
Query the type of the trigger output signal in the burst mode of the specified channel.
Parameter Name Type Range Default
[] Discrete 1|2 1
{POSitive|NEGative|OFF} Discrete POSitive|NEGative|OFF OFF
Explanation  This command is applicable to the burst mode (N cycle, infinite or gated,
[:SOURce[]]:BURSt:MODE ) in internal or manual trigger
( [:SOURce[]]:BURSt:TRIGger:SOURce ). When internal or manual trigger is
selected, you can set the instrument to output the trigger signal with the
specified edge (rising edge or falling edge) from the corresponding
[Mod/Trig/FSK/Sync] connector at the rear panel or turn off the trigger
signal output.
 When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
Return Format The query returns POS, NEG or OFF.
Example :SOUR:BURS:TRIG:TRIGO POS /*Set the edge type of the trigger output signal in
the burst mode of CH1 to rising edge*/
:SOUR:BURS:TRIG:TRIGO? /*Query the type of the trigger output signal in
the burst mode of CH1 and the query returns
POS*/
Related
Commands
[:SOURce[]]:BURSt:MODE
[:SOURce[]]:BURSt:TRIGger:SOURce