RIGOL DG1000Z Series - Manual (Page 71)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-59
:OUTPut[]:SYNC:DELay
Syntax :OUTPut[]:SYNC:DELay {|MINimum|MAXimum}
:OUTPut[]:SYNC:DELay? [MINimum|MAXimum]
Description Set the output delay time of the sync signal on the [Mod/Trig/FSK/Sync]
connector of the specified channel at the rear panel.
Parameter Name Type Range Default
[] Discrete 1|2 1
Real 0s to the carrier period 0s
Explanation  The output delay time of the sync signal refers to the output delay time of the
sync signal on the [Mod/Trig/FSK/Sync] connector of the specified channel
at the rear panel relative to the output signal of the output connector at the front
panel.
 When [] is omitted, the commands set and query the related parameters of
CH1 by default.
 When the modulation ( [:SOURce[]]:MOD[:STATe] ), sweep
( [:SOURce[]]:SWEep:STATe ) or burst ( [:SOURce[]]:BURSt[:STATe] )
function is enabled, the delay setting is invalid.
Return Format The query returns the delay time of the sync signal in scientific notation with 7
effective digits, for example, 1.000000E-03 which denotes that the delay time of the
sync signal is 1ms (namely 0.001s).
Example :OUTP1:SYNC:DEL 0.001 /*Set the output delay time of the sync signal on the
[Mod/Trig/FSK/Sync] connector of CH1 at the rear
panel to 1ms (namely 0.001s)*/
:OUTP1:SYNC:DEL? /*Query the output delay time of the sync signal on the
[Mod/Trig/FSK/Sync] connector of CH1 at the rear
panel and the query returns 1.000000E-03*/
Related
Commands
[:SOURce[]]:BURSt[:STATe]
[:SOURce[]]:MOD[:STATe]
[:SOURce[]]:SWEep:STATe