RIGOL DG1000Z Series - Manual (Page 260)

RIGOL Chapter 5 Appendix
5-10 DG1000Z Programming Guide
Appendix B: Factory Setting
The factory settings are as shown in the table below. Note that the items marked with “*” are set at the
factory and are related to the set of the users and will not be affected by the reset operation.
Parameters Defaults
Channel Parameters
Current Carrier Waveform
Sine
Output Impedance HighZ
Output Load 50Ω
Sync Output On
Sync Polarity Pos
Sync Delay 0s
Channel Output Normal
Output Mode Normal
Gated Polarity Pos
Range Auto
Waveform Sum Switch Off
Sum Source Sine
Sum Frequency 1kHz
Sum Ratio 100%
Basic Waveform
Frequency
1kHz
Amplitude 5Vpp
Amplitude Unit Vpp
Offset 0V
DC
Start Phase 0°
Square Duty Cycle 50%
Ramp Waveform Symmetry 50%
Pulse Duty Cycle 50%
Pulse Width 500μs
Pulse Leading Edge 20ns
Pulse Trailing Edge 20ns
Harmonic Type Even
Harmonic Order 2
Harmonic Phase (7) 0°
Harmonic Serial Number 2
Harmonic Amplitude (7) 1.2647Vpp
Harmonic State Off
User-defined X0000000
Arb Waveform
Sample Rate
20MSa/s
DC Offset 0V
DC
Arb Waveform Mode Frequency
Built-in Arbitrary Waveform Sinc
Insret Waveform
Insert position
1
Insert Way Insert
Cycles 1
Points 8
High Level 2.5V
Low Level -2.5V
Edit Points