RIGOL DG1000Z Series - Manual (Page 21)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-9
:COUPling Commands
The :COUPling commands are used to set the related information of the channel frequency coupling,
amplitude coupling and phase coupling as well as enable and disable the three coupling functions.
Command List:
 :COUPling:AMPL:DEViation
 :COUPling:AMPL:MODE
 :COUPling:AMPL:RATio
 :COUPling:AMPL[:STATe]
 :COUPling:FREQuency:DEViation
 :COUPling:FREQuency:MODE
 :COUPling:FREQuency:RATio
 :COUPling:FREQuency[:STATe]
 :COUPling:PHASe:DEViation
 :COUPling:PHASe:MODE
 :COUPling:PHASe:RATio
 :COUPling:PHASe[:STATe]
 :COUPling[:STATe]
Note: The coupling function is only valid when both the two channels are in the basic waveform (Sine,
Square, Ramp) or arbitrary waveform (except DC) mode.