RIGOL DG1000Z Series - Manual (Page 180)

RIGOL Chapter 2 Command System
2-168 DG1000Z Programming Guide
[:SOURce[]]:SWEep:TIME
Syntax [:SOURce[]]:SWEep:TIME {|MINimum|MAXimum}
[:SOURce[]]:SWEep:TIME? [MINimum|MAXimum]
Description Set the sweep time of the specified channel.
Query the sweep time of the specified channel.
Parameter Name Type Range Default
[] Discrete 1|2 1
Real 1ms to 500s 1s
Explanation  The sweep time refers to the time required for the instrument to sweep from
the “Start Frequency” ( [:SOURce[]]:FREQuency:STARt ) to the “Stop
Frequency” ( [:SOURce[]]:FREQuency:STOP ).
 When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
 After the “Sweep Time” is modified, the signal generator will output the sweep
waveform from the specified “Start Frequency”.
Return Format The query returns the sweep time in scientific notation with 7 effective digits, for
example, 5.000000E+00 (the sweep time is 5s).
Example :SOUR1:SWE:TIME 5 /*Set the sweep time of CH1 to 5s*/
:SOUR1:SWE:TIME? /*Query the sweep time of CH1 and the query returns
5.000000E+00*/
Related
Commands
[:SOURce[]]:FREQuency:STARt
[:SOURce[]]:FREQuency:STOP
[:SOURce[]]:SWEep:TRIGger[:IMMediate]
Syntax [:SOURce[]]:SWEep:TRIGger[:IMMediate]
Description Trigger a sweep immediately in the specified channel.
Parameter Name Type Range Default
[] Discrete 1|2 1
Explanation  This command is only applicable to manual trigger
( [:SOURce[]]:SWEep:TRIGger:SOURce ) and is only valid when the output
of the corresponding channel is turned on.
 When [:SOURce[]] or [] is omitted, the system sets the related
parameters of CH1 by default.
Example :SOUR1:SWE:TRIG /*Trigger a sweep immediately in CH1*/
Related
Commands
:OUTPut[][:STATe]
[:SOURce[]]:SWEep:TRIGger:SOURce