Yaskawa J50M Instructions - Manual (Page 267)

Code Causes
078
079
. ---- . . ----- . . . . . ------ ----- . . . . . .. -—. . . . . . . . . . ------ ---
I
081
I
082 -------1------- -------- . . . . . . .. . .------ . . . .------ ------
083
---------- ------- ----- . . . . . . . . ----- . . . . . . . . . . . . .
084 MIRROR IMAGE
---- . . . . . ---- . ----- ----- ------ --- ---- ------ ------
MIRROR IMAGE IS ON WITH G36 TO
G38.
085 PROG ERROR (G36/37)
. . . . . . . . .- . ----- . . . . . . . . . .
COMMAND OF (J) ON MORE - --
ONE AXIS AT G36
086
. . . . .
PROG ERROR
----- ----- ----- ------ . . . . . . . . . . . ..- . . . . . . . . .
COMMAND OTHER THAN K AT G38
087
- -
PROG ERROR
- - - - - - -. ----- . ----- . . . .
TOUCH SWITCH NOT ‘ON WHEN
MOTION REACHES AT END POINT BY
G36 TO G38 COMMANDS,
Code
088
- - - - -
089
- - - - - -
090
----- . .
091
----- .
092
---
093
- - - - - -
094
095
----
096
--
Causes
PROG ERROR
----- ----- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TOUCH SWITCH CALCULATION ERROR
AT G36 TO G38 COMMANDS.
PROG ERROR
----- . . . . . . . . . . . . . . . . . . . . . . . . . .
A CODE THAT CANNOT BE
COMMANDED DURING THE BLOCK
OF G93 OR G93 MODE HAS
BEEN COMMANDED.
TAP ERROR
----- ..—. ----- . .
SLPC (SPINDLE LOOP COMMAND) HAS
NOT BEEN TURNED ON DURING EXE-
CUTION OF SOLID TAPPING.