Yaskawa J50M Instructions - Manual (Page 157)

#6050 to #6055
#6056 to #6o6l
#6062 (Skip)
#6063 (Skip)
#6156 to #6161
#6280 to #6284
#6286 to #6290
#6292 to #6296
#6298 to #6302
#6400 to #6404
#6406 to #6411
#6444 to #6448
#6450 to #6454
#6456 to #6411
(Servo control)
(PG multiplication factor)
(Error detect area)
(Rapid traverse rate)
(Linear time 1)
(2-step switch speed)
(Linear time 2)
(Backlash compensation amount)
(Move amount/ motor rotation)
(Minimum move amount)
(Servo input gain)
( K p )
. After reading-in of parameter tape
4.3.8 INTERNALTOGGLE SWITCHES
The following switches maybe easily turned on and
offonthe NC operator’s panel even when they cannot
be operated on the machine control station. Setting
numbers and their contents are as follows.
7 6 5 4 3 2 1 0
o 0 1
1 I
I
#6002
7 6 5 4 3 2 1 0
0 0 0 0 0 0 1
b l o c k
‘ S t a r t
lock
*Optional block skip
‘ D r y r u n
I I
‘Optional stop
I
lock
‘Auxiliary function lock
Setting data Machine’s switch Result on/off
“O” = OFF OFF OFF
ON ON
OFF ON
ON ON
The functions of the internal toggle switches work
only when parameter #6006D3 = 1 (internal toggle
function on). off, only the
the machine control panel work.
4.3.9 OPERATION TIME DISPLAY
The system counts the duration of automatic
operation and it can be displayed. This function
permits the display of the time it has been taken for a
piece of work or the total operational time of the
system.
1.
2.
Procedure of display
Depress the ALM key, then select a screen
of running time with the PAGE key as
+
shown below.
Three kinds of operation time will be dis-
played in hours, minutes, and seconds.
Top : Total operating time after
Middle : Total operating time of CYCLE
START
Bottom: Total operating time of FEED
Resetting display
Each operation time display can be reset inde-
pendently by the following procedure.
When operating times are displayed :
A . POWER ON time at the top
will be reset
CYCLE START time in the
middle will be reset.
c . FEED time at the bottom
will be reset
The timers of operation time preserve data unless
they are reset, even after power is turned off.
If the machine control station is provided with the
switches that turn on and off the above machine
functions, the state of a switch on the machine’s
control panel is ORed with that of the NC operator’s
panel will determine the machine condition.
149