Yaskawa J50M Instructions - Manual (Page 226)

PARAMETER NUMBERS AND THEIR CONTENTS
(Cent’d)
D7 D6 D5 D4 D3 D2 D1 DO
I
D7 1
0:
D6 1:
0:
D5
0:
D4 1:
0:
D3 1:
0:
1:
0:
1:
0:
1:
0:
Makes editing interlock 09000 through
09999 effective and prohibit the external 1/0
operation (tape in/out).
Makes editing interlock 09000 through
09999 ineffective.
Erases and stores the previous O number
when loading a tape provided with an O.
ALREADY IN will be displayed if the
same O number exists when a tape
with an O is loaded.
Executed ON/OFF control of RTS signal
during
operation until loading
ends.
Sets RTS signal to ON state during
operation until loading ends.
Refers to DR (Data set ready) during
RS
operation.
Does not refer to DR (Data set ready)
during RS
operation.
Outputs 00 with O through 9999 OUT.
Does not output 00 with O through
9999 OUT.
Displays the O number when the power
supply is turned on/off.
Displays 00 when the power is turned on.
Employs the value following address O
or N as the program number
in one block) .
Employs the value following address O
as the program number.
Considers M02, M30 and M99 as the
program end when machining data is stored
into memory.
EOB code is provided for the top of the O
number at punch-out (O-9999 OUT).
Does not consider M02, M30 and M99 as the
program end when machining data is stored
into memory.
EOB code is not provided for the top of the O
number at punch-out (O-9999 OUT).
o:
D6 1:
0:
D5 1:
0:
D4 1:
0:
D3 1:
0:
1:
0:
1:
0:
DO 1:
0:
Sets input unit of parameter setting
1 rein-l when specifying the S5 digits.
Enables binary search of EDIT
Character search is also possible if
the NEXT key is pressed,
to
Enables search of EDIT /MEM character
o n l y .
Makes editing display of 090000 through
09999 Interlock effective.
Makes editing display through 09999
Interlock ineffective.
Makes intermediate POT display effec-
t i v e .
Makes intermediate POT display inef-
f e c t i v e .
Makes tool POT word display effective.
Makes tool POT byte display effective.
Enables writing word
Enables writing bytes in keep memory.
No parity bit when punching out an
ISO tape
Parity bit exists when punching out
an 1S0 tape
Enables read of ISO tape even without parity.
Disables read of 1S0 tape without
p a r i t y .
D7 4th axis is rotary axis, stored stroke
limit is
1: Effective
O: Ineffective
D6 Ignorance additional axis
1:
o: OFF
Note: When this parameter setting is changed,
turn off the power. Setting the parameter except
to
display shows additional axis is provided.
However, this additional axis cannot be effective
without changing hardware
Set the address for punch-out and display
on the additional axis.
1: Sets input unit of parameter setting to
10 rein-1 when the S5 digits.
218