Yaskawa J50M Instructions - Manual (Page 235)

#6264
1
Specifies the feedrate for the respective positions on
the jog feedrate select switch.
Setting : “l” = 1 mm/minor inch/rein
Setting range: 30000
The manual feedrates set in parameters #6233 to
#6264 can be reduced to a tenth of the original set-
ting. This applies to the settings on all switch posi-
tions lower than the value specified in this parameter
#6265.
Typical settings Setting : 0 to 32 (switch position)
Typical Settings
Parameter
Continuous
manual feedrate
1 I
Switch
position
N Setting #6250 = O #6265 = 10
#6233 o 0 0 o I t
1
#6234 1 1 0.1
2
I
#6235 2
#6236 4
#6266 to #6269:
0.6
8 I 0.8 Specifies the maximum spindle speed, respectively,
for gears 1, 2, 3 and 4 (specifiable only in S5-digit
designation).
Setting : “l” = 1 rein-l or 10 rein-l
(Set by parameter #6022 D7)
6
I
#6239 10 10 1.0
7 #6240 12 12 1.2
Setting range : 0 to 32767
10
I #6243 25 25 25
11 #6244 I
30 30 30
12 #6245 40 40 40
13 #6246 50 50 50
14 60 60 60
15 #6248 80 80 80
16 #6249 100 100 100
17 #6250 120 120 120
Specifies the speed command output value to the
spindle motor when a gear shift (GR O) input is
entered.
Specifies No. of bits occupied in 32767 or 4095 direct-
ly.
#6251 150 I 150 150
19 #6252 200 200 200
#6253 250 250 250
#6254 300 300 300
Setting value:
Gear shift spindle motor speed
Spindle motor max speed
(Command = 10 V)
20
21
22
23
24 -
x 4095 --- 12-bit output
Gear shift spindle motor speed
Spindle motor max speed
(Command = 10 V)
25
26
x 32767 --- Analog output #6260 1200 1200
28 #6261 1500 1500
29 2000 2000 2000
30 #6263 2500 2500 2500
#6264 3000 3000 3000
Setting range: O to 32767
I
I I 1
r
I I
2 2 7