Yaskawa J50M Instructions - Manual (Page 170)

4.8,3 VERIFYING PART PROGRAM TAPE (Cent’d) (3)
f. Depress VER key.
The tape starts to compare the con --
tents of the part program memory to the con-
tents of the part program tape. During
this operation,
keeps blinking. If
a mismatch is found, “INPUT ERROR” blinks
a.
on the CRT. When a match is found and
this operation is completed, the tape reader
b.
stops, upon which display is erased.
If the keyed in program number is not found
c.
in the memory, “NOT FOUND! “ blinks.
In this case, depress the CAN key and start
with the operation of d.
Notes :
1. The operations for verification with a program num-
ber different from the program number punched on
the tape are the same as those of (2) above. The input
program number is processed in preference to the
punched program number.
e.
Verifying a tape containing multiple part
programs
Multiple part programs punched in a single
tape are continuously verified by the follow-
ing operations:
Select the EDIT mode.
Depress the PROG function key.
Set the part program tape to the tape read-
er.
Depress the RESET key.
Depress the VER key.
When M02 M30 ; or M99 ; is read, the tape
reader does not stop but all the part programs are
continuously verified up to code. When the veri-
fication is completed, the tape reader stops at the
position of code.
2. Verification by the operation of regards
the punched information as the information on the
input program number.
When verifying a tape containing program numbers,
no program number should be input.
162