Yaskawa J50M Instructions User Manual

Page 171

4.8.4 SUMMARY OF EDITING OPERATION

Edit

No.

switch

PRM

Mode

Procedure

Parameter number -

Data

Operation

Storing from NC operator’s panel
keyboard

Storing from tape (Note 1) (Note 2)

EDIT

Punch out (Note 3)

Matching with tape (Note 1]

Storing from NC operator’s panel
keyboard

Setting number

Data

Offset number

Address data

Storing from NC operator’s panel

keyboard

Storing from tape

Punch out

OFS

Matching with tape

Clear of all offsets

OFF

One

Tape with number O

part

program Tape without number

(Note 4)

❑

-, Program number

from
tape

All part

programs on tape

Addition to registered part

program

Designated part program

OFF

Punch
out

with
tape

❑

- -9999-.

All

part programs

Program number -

Address data -- ALTER

[Set to address data just before

addition) -

to address data to be deleted)

(Set address data at head of

to be deleted)

Address data to be searched

to be searched

❑

“

with number O

EDIT

M E M
EDIT

PROG

All part

programs on tape

of address data (Note 5)

OFF

Add of address data (Note 5)

Edit

OFF

Delete of one address data

Delete of one block (Note 6)

Address search

PROG

ALM

OFF

EDIT

Notes :

1. If the

tape contains setting information, it is also stored and

5. Within the limit of 32 characters, addition of multiple address

matched at the same time.

data and the change to one address data are permitted.

When the cursor to the address data

in the middle of a block

and EOB and ERASE keys are depressed, the data following

the cursor position is deleted.

2. When data has been stored from a parameter tape, turn the 6.

power on and off.

3. Setting is punched out at the same time.

4. Storing of a part program having a program number different

from program number O on tape is performed by the same

operation as for “tape without program number O.

163