Yaskawa J50M Instructions - Manual (Page 222)

PARAMETER NUMBERS AND THEIR CONTENTS
(Cent’d)
D3 1: Enables the internal toggle switches.
O: Disables the internal toggle switches.
See #6001, #6002
1: Enables dry run response to the
rapid traverse command.
O: Disables dry run in response to the
rapid traverse command.
1: Causes an alarm (“001-004”) upon cycle
start when reference point return is not
made after turning the power on.
O: Causes no .
: Set “ 1“ when pitch error compensa-
tion or stored stroke limit is pro-
v i d e d .
When this parameter is set to 1,” Cycle Start is
not activated unless reference point return of all
the axes have not be completed. Setting it to “O”
determines whether reference point return is
required or not for each axis.
Refer to parameters #6011 DO to D3.
D O 1: Enables automatic coordinate system
setting
2: Disables automatic coordinate system
setting.
Refer to #6630 to #6639.
D6 D5 D3 D2 DO
D7
D5
D4
D3
0:
1:
0:
1:
0:
1:
0:
1:
0:
1:
0:
Disables start interlock after edit.
Enables start interlock after edit.
Employs the entered tool compen-
sation value in place of the old value.
Adds the newly entered tool compensa-
tion value to the soterd value to establish
another offset.
Enables error detect ON mode at dwell.
Disables error detect On mode at dwell.
Provides output during rewinding.
Provides no output during rewinding.
Sets the least increment to O. 0001 in.
Sets the least increment to O. 001 mm.
Makes the spindle override 100% during
tapping by G84.
Does not make the spindle override 100%
during tapping by G84.
DO
1: Establishes the prohibited area of the
3rd, 4th, and 5th stored stroke limit
outside the boundary.
o: Establishes the prohibited area of the
3rd, 4th, and 5th stored stroke limit
inside the boundary.
1: Establishes the 2nd prohibited area of
stored stroke limit outside the boundary.
o : Establishes the 2nd prohibited area of
stored stroke limit inside the boundary.
D6 D5 D3 D2 DO
D6
D5
D4
D3
D2
DO
1:
0:
0:
1:
0:
1:
0:
1:
0:
1:
0:
1:
0:
Rewinds at M30 in Tape operation
with YASNAC standard tape reader
(lst
Does not rewind at M30 command in Tape
operation with YASNAC standard tape
reader
O number is changeable with operation.
O number is not changeable with operation.
Feed hold block stop
tapping with G84
Feed hold block stop
tapping with G84
ineffective when
effective when
Manual absolute effective in the G
mode.
Manual ineffective in the
mode.
Changes approach speed to jog speed
when restarting program.
Changes approach speed to fast feed
when restarting program.
Does not clear the common variables
of #100 through #149.
Clears the common variables of
through #149.
Requires Edit interlock for Manual Zero
Setup.
Does not require Edit interlock for
Zero Setup
Note: Some controls are not provided with
the parameter #6008.
1: Up to 256 characters can be set in 1 tape
read block.
o: Up to 128 characters can be set in 1 tape
read block.
214