Yaskawa J50M Instructions - Manual (Page 242)

PARAMETER NUMBERS AND THEIR CONTENTS
(Cent’d)
Y-axis
Z-axi s
4th axis
Servo input in the order of X-, Y-, Z- and 4th-axes.
Setting : “ 1“ = 1 r/rein/volt
Setting range : 250 is set.
Spindle indexing speed rate.
Setting: “1” = 500 p p s
Setting range: O to 32767
Spindle indexing creep rate.
Setting: = 500 pps
Setting range: O to 32767
Spindle indexing & spindle stop confirmation
timer.
Setting:
8
Setting range: O to 255
Spindle indexing and origin position.
Setting:
Setting range: O to 4095
F2
Rapid traverse override of and F2.
Setting : “l” = 1 mm/min or 0.1 inch/rein
Setting range : 0 to 30000
Synchronization offset gain upon solid tap
stationary cutting feed
Setting:
t i m e s
Setting range: -32768 to
Synchronization offset gain upon solid tap
feed
Setting : “ 1“ = 0.0001 times
Setting range : 0 to 32767
Solid tap R point return feedrate magnification
Setting: = 0.1 times
S e t t i n g r a n g e : O t o
Solid tap spindle revolutions upper limit
S e t t i n g to
Spindle revolutions against the 10 V command of the
gear used on the solid tap
Setting:
= rein-l
Setting range: O to 32767
Spindle stop acknowledgment revolutions in the G93
spindle position loop
Setting:
=
Setting range: o to 30
In-position width area upon solid tap R point
lead-in
Setting:
= spindle PG
Setting range: O to 32767
X-axis
Y-axis
234