Yaskawa J50M Instructions - Manual (Page 12)

2.1.2 ADDRESS AND FUNCTION CHARACTERS (Cent’d)
Table 2.3 Function Characters
EIA Code
I
ISO Code Meanings
Blank
I I
Error in significant data area in EIA
Disregarded in ISO
BS Disregarded
T a b I HT Disregarded
CR LF End of Block
C R D i s r e g a r d e d
SP SP Space
ER
I
Rewind stop
Upper shift
LC Lower shift
2-4-5 bits C o n t r o l ( C o m m e n t s t a r t )
2-4-7 bits Control in (Comment end)
•!- + Disregarded, User macro operator
- M i n u s s i g n , U s e r m a c r o o p e r a t o r
o t o 9 o t o 9 Numerals
a t o z Z Address characters, User macro operator
/ Optional skip
DEL Disregarded (Including Mark)
Decimal point
I
Parameter
# Sharp (Variable)
setting
* * Astrisk (Multiplication operator)
Equal mark
[ [ Left bracket
1
1 Right bracket
o User macro operator
$ $ User macro operator
User macro operator
? User macro operator
N o t e s :
Remarks
EIA :
Special
code
E I A :
Special
code
Characters other than the above cause error in significant data area.
2. Information between Control Out and Control In is ignored as insignificant data.
3. Tape code (EIA or 1S0) can be switched by setting.
4