Yaskawa J50M Instructions - Manual (Page 232)

PARAMETER NUMBERS AND THEIR CONTENTS
(Cent’d)
G - 5
G - 6
G-7
G-8
G-9
G - 1 0
#6120 to #6129:
Specify up to 10 G codes for calling user
macros.
S e t t i n g r a n g e :
(except for the G code specified by
NC machine builder)
M– 1
M–2
M-3
M-4
#6130 to #6133 :
Specifies up to 4 M codes for calling user macros.
Setting range : 0 to
Note : MOO, MO1, M02, M30 and M90 to M99 cannot
be called by user macros.
1: Allows the T code to call a user macro.
O: Does not allow the T code to call a user
macro.
#6141
224
I
I
#6141 to #6149 :
Specifies the feedrate change for one increment on
a m a n u a l p u l s e g e n e r a t o r , f o r
to F9,
respectively, of -digit designation.
Setting : “ 1“ = 0.1
Setting range : 0 to 255
magnification for the deviation pulse at
the most rapid traverse time of the X-axis, in the
alarm zone in the successive order of X-axis,
axis, Z-axis and 4th axes.
Setting : “l” =
Setting range : 1 to 200
Specifies the magnification against the deviation pulse
at the maximum speed of the spindle in the spindle
alarm zone.
Setting: = 1%
S e t t i n g r a n g e : 1 t o
Note:
T h
e
is in #6150 to
is The parameter value is also rewritten to
120.
Specifies error detect on area for X-, Y-, Z- and 4th
axes, respectively.